ASTM F – Standard Specification for Pressure-rated Polypropylene (PP) Piping Systems. CSA B – Polypropylene (PP-R) Pipe and Fittings for. ASTM F “Pressure-rated Polypropylene (PP) Piping Systems”. Presented to the IAPMO Standards Review Committee on May 8, General: The. Find the most up-to-date version of ASTM F at Engineering
|Published (Last):||7 December 2007|
|PDF File Size:||9.62 Mb|
|ePub File Size:||17.43 Mb|
|Price:||Free* [*Free Regsitration Required]|
This abstract is a brief summary of the referenced standard. When tested according to the procedures provided herein, the piping components shall adhere to specified requirements for workmanship, awtm, longitudinal reversion, melt flow rate, impact resistance, thermal stability and oxidative induction time OIThydrostatic pressure, thermocycling, and oxidative stability in potable chlorinated water. Link to Active This link will always route to the current Active version of the standard.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. This specification establishes the requirements for polypropylene PP piping system components such as pipe, fittings, valves, and manifolds used in water service lines, hot-and-cold water distribution, hydronic heating, and irrigation systems to transport industrial process fluids, effluents, slurries, municipal astn, etc.
The values asm in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. Work Item s – proposed revisions of this standard.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The piping system components covered ast are made to metric sizes and IPS schedule 80 sizes, and pressure asym for water service and distribution supply. Included are criteria for materials, workmanship, dimensions and tolerances, product tests, and marking for polypropylene PP piping system components such as pipe, fittings, valves, and manifolds.
Historical Version s – view previous versions of standard. The user shall consult the manufacturer to determine whether the material being transported is compatible with the polypropylene piping system and will not affect the service life beyond limits acceptable to the user.